Units which are the last receiver or generate data are called hosts or data terminal equipment.
2.
Typically, the DTE port provides timing to the data terminal equipment while the WAN port dictates the rate.
3.
Serial port B was wired as a Data Terminal Equipment ( DTE ) port and had no modem control.
4.
Data to be transmitted are transferred to a modem from Data terminal equipment ( e . g . a computer ).
5.
Burst transmission, however, enables communications between data terminal equipment ( DTEs ) and a data network operating at dissimilar data signaling rates.
6.
SVCs are used in situations where data transmission is sporadic and / or not always between the same data terminal equipment ( DTE ) endpoints.
7.
The data terminal equipment may be a single piece of equipment or an interconnected subsystem of multiple pieces of equipment that perform all the required functions necessary to permit users to communicate.
8.
The current revision is " TIA-232-F Interface Between Data Terminal Equipment and Data Circuit-Terminating Equipment Employing Serial Binary Data Interchange ", issued in 1997.
9.
The current version of the standard is " TIA-232-F Interface Between Data Terminal Equipment and Data Circuit-Terminating Equipment Employing Serial Binary Data Interchange ", issued in 1997.
10.
The full title of the standard is " EIA-449 General Purpose 37-Position and 9-Position Interface for Data Terminal Equipment and Data Circuit-Terminating Equipment Employing Serial Binary Data Interchange ".
मोबाइल